Attic Spray Foam Removal in Carlisle is the job of cutting out cured polyurethane foam from your roof space, bagging it and getting your loft back to a mortgageable, breathable state. We handle open cell and closed cell foam, overspray on cables and timbers, and the mess nobody else wants. If a lender has flagged your loft, or you need attic spray foam extraction in Carlisle Cumbria, we quote the same week and work to a fixed price.
Attic Spray Foam Removal in Carlisle means physically cutting, prizing and vacuuming cured spray foam off the underside of your roof deck, rafters and purlins, then bagging it for licensed disposal. Foam sprayed between 2005 and 2018 is usually the problem: it was sold as insulation, it set hard, and it traps moisture against the timber. We cut it back in sections with a spray foam removal saw and an oscillating multi-tool, work around cables and downlights, then run an industrial vacuum and air scrubber so the loft is safe to walk through the same day.
Most Carlisle homeowners call us for one of three reasons. A mortgage lender has refused to lend until the foam is gone. Condensation has started dripping onto stored boxes in a Stanwix or Morton loft. Or a surveyor has flagged roof timber rot under closed cell foam. If you need attic spray foam extraction near me Carlisle, we survey first with a thermal imaging camera, tell you honestly whether the timbers are salvageable, and only then book the removal. No foam comes out until you know what is underneath it.
Every Carlisle job is quoted as a complete package, so you are not paying for extras halfway through. Removal, containment, disposal and documentation are all in the price. If we find rot or damaged cabling under the foam, we tell you what it costs to put right before we touch it.
Cutting and prizing out open cell and closed cell foam from rafters, purlins, roof felt and ceiling joists. We work around cables, downlights and pipework by hand so nothing gets sliced that should not be.
Floor protection, a sealed loft hatch, a negative air machine and an air scrubber running for the duration. This is what keeps foam dust out of your bedrooms and off your landing carpet.
All removed foam is bagged on site and taken for licensed disposal through registered waste routes. You get the paperwork, which matters if a buyer's solicitor asks how the foam was disposed of.
Once the foam is off we inspect every exposed rafter and joist for rot, beetle damage and moisture staining. Anything suspect is photographed and reported with a plain-English recommendation.
A before-and-after photographic record with the date, address and scope of removal, emailed within 24 hours. Carlisle lenders and surveyors accept it as evidence the foam has been properly taken out.
Foam removal alone does not stop condensation returning. We tell you what ventilation or insulation to fit next, and what not to fit, so the roof deck can breathe properly.
We inspect the loft, check foam thickness and type, and look for rot, condensation and overspray on cables. A thermal imaging camera shows where the foam is hiding moisture. You get a fixed written price the same day, usually within two hours of the visit.
Before any cutting starts we lay floor protection, seal the loft hatch and set up a negative air machine with an air scrubber. That keeps foam dust out of your living space. Setup takes about 45 minutes on a typical Carlisle semi.
We cut the foam into manageable sections with a spray foam removal saw and an oscillating multi-tool, working carefully around cables, downlights and pipework. An industrial vacuum pulls the debris straight into sealed bags. A standard 40 square metre loft takes one to two days.
Once the foam is out we vacuum every rafter, sweep the ceiling joists and inspect the timber for rot or beetle damage. Any soft timbers get photographed and reported to you with a straightforward recommendation, not a sales pitch.
Foam is bagged and removed for licensed disposal, and we leave you a written removal record with before-and-after photos. That document is what your lender, surveyor or buyer's solicitor will ask for. We email it within 24 hours of finishing.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Cuts cured foam into manageable sections on rafters and roof decks. It is the workhorse for closed cell foam that has set hard.
Used for precision cutting around cables, downlights and pipework where a saw would be too aggressive and risk damaging services.
Pulls foam dust and debris straight into sealed bags during cutting, keeping airborne particles down to a minimum inside the loft.
Creates negative pressure in the loft and filters the air, so foam dust cannot drift down through the hatch into your living space.
Reveals where foam is trapping moisture and which timbers are damp before we cut, so we know what we are dealing with.
Fires dry ice pellets to freeze and crack foam off fragile felt and old sarking without tearing the surface underneath.
Worn by every technician for the full job. Cured foam dust is not something you want in your lungs, and we do not ask you to be in the loft while we work.
A three-bedroom terrace in Stanwix with closed cell foam sprayed across every rafter. The buyer's lender refused to proceed, and the surveyor had flagged possible damp in two purlins. The loft was full of stored boxes and had not been entered in years.
Foam removed in two days, timbers vacuumed and photographed. The two suspect purlins were treated rather than replaced. The written removal record went to the lender within 24 hours and the sale completed three weeks later.
A 1970s semi in Harraby with foam sprayed between the rafters and condensation dripping onto Christmas decorations and old suitcases. The homeowner had already replaced two ceiling boards and was about to replace a third.
Foam cut out in a single day with two technicians on site. Negative air machine ran throughout and no dust reached the landing. Within a fortnight the dripping had stopped and the ceiling boards dried out without further replacement.
A Denton Holme terrace where foam covered every joist, making the loft impossible to board or store anything in. The homeowner wanted a proper storage floor but could not get a joiner to touch it while the foam was in place.
Foam removed in a day and a half, timbers cleaned and levelled. The homeowner boarded the loft the following month. The roof deck stayed ventilated, so no condensation returned through the first winter.
Spray foam causes a predictable set of problems in Carlisle lofts, and most of them get worse the longer they are left. Here is what we see most weeks and how we deal with it.
Ask a pro →We remove the foam, photograph the exposed timbers and issue a written removal record within 24 hours. That document goes to your lender or your buyer's solicitor and usually clears the objection. Most Carlisle cases we handle complete within three to four weeks.
We cut the foam back, restore airflow across the roof deck and check the timbers for early rot. Where ventilation is inadequate we tell you exactly what to add. Most homeowners see the dripping stop within a fortnight of removal.
Our survey uses a thermal imaging camera to find damp timber before we cut. We remove the foam, expose the affected area and report honestly on what is sound and what needs replacing. Catching it early saves thousands.
We cut foam away from cables by hand with an oscillating multi-tool rather than a saw, and we check circuits before we leave. Any cable we find damaged gets flagged in the removal record so your electrician knows what to expect.
Typical 2026 pricing in Carlisle runs from around 1,800 to 4,500 pounds for a standard domestic loft, depending on foam type, thickness and access. Closed cell foam takes longer to cut than open cell, and a loft full of stored items adds labour. We survey first and give you a fixed written price, so the number you agree is the number you pay.
Yes. We remove open cell and closed cell polyurethane foam from lofts across Carlisle and Cumbria, including foam sprayed directly onto roof timbers, felt and cables. We use a spray foam removal saw, oscillating multi-tool and industrial vacuum, and we work around pipework and electrics by hand. Foam bonded to fragile felt sometimes needs dry ice blasting instead, which we also carry.
It is safe when it is done with containment and the right PPE. Cured foam is largely inert, but cutting it releases fine dust that you do not want in your home. We seal the loft hatch, run a negative air machine and air scrubber, and our technicians wear PPE respirators. The loft is safe to enter as soon as we finish and clear up.
Removal usually resolves the problem. Lenders object to foam because it hides the roof timbers and traps moisture, not because the foam itself is dangerous. Once it is out, we photograph the exposed rafters and issue a written removal record. Carlisle surveyors and lenders accept that document in the vast majority of cases, and it also helps when you come to sell.
Spray Foam Removal near meOur core spray foam removal service covers lofts, roofs and cavity walls across Carlisle. If you are searching for spray foam removal near me, this is the service that gets foam out of your property, bagged and documented.Explore →
Same day Spray Foam RemovalWhen a lender or buyer needs foam gone quickly, we offer same day spray foam removal where the diary allows. Call before noon and we can often have a technician in your Carlisle loft that afternoon for a survey and start date.Explore →
24/7 Spray Foam RemovalWater ingress through a foam-filled roof does not wait for office hours. Our 24/7 spray foam removal line takes emergency calls from Carlisle and the surrounding Cumbria villages, and we will talk you through containment until we arrive.Explore →
Residential Spray Foam RemovalMost of our Carlisle work is residential spray foam removal in semis, terraces and detached homes. We protect carpets and stairwells, keep dust out of living space and leave the loft clean enough to use the same day.Explore →
Commercial Spray Foam RemovalWe also handle commercial spray foam removal for Carlisle workshops, farm buildings and small industrial units. Larger roofs are surveyed and phased so your operation keeps running while we cut foam out in sections.Explore →
Loft Spray Foam RemovalLoft spray foam removal Carlisle homeowners ask for most often. We clear foam from rafters, purlins and roof felt, restore ventilation and leave the space ready for proper insulation or boarding.Explore →
Roof Spray Foam RemovalFoam sprayed directly onto the underside of roof tiles or sarking board traps water and rots timbers. Our roof spray foam removal service strips it back and lets the roof breathe again, which is often the difference between repair and re-roof.Explore →
Spray Foam Insulation RemovalSpray foam insulation removal is the same physical job as attic foam removal, but it also covers foam in walls and floors. We assess what is worth keeping and what has to come out before we quote.Explore →Fixed written price, CHAS accredited, and a removal record your lender will accept. Call Spray Foam Sphere UK on 0122 891 5049 and we will book your survey, usually within five working days.
Get a fixed quote 0122 891 5049 →Call 0122 891 5049 or email [email protected] and we will get back to you the same working day. We cover all CA postcodes and can usually survey your loft within 48 hours. For emergency spray foam removal Carlisle 24/7, call any time.